AVS Fencing Blog

What is a Panel Fence

A pre-made timber panel, of differing styles and qualities, that are fixed between two posts.

Types of Panel

Panels are available in 3 different colours, a light beige (pressure treated), gold (orange/brown) and dark brown which are dipped. Check stocks for the range at your branch.

The styles can be broken down into:

Lap Panels - A waney edged board, overlapped and fixed horizontally within a batten frame, described as fully framed – meaning they have timber around the outside edge. They also have vertical battens fixed across the face and back of the panel to strengthen the laps.

Close board Panels - A feather edge board, overlapped and fixed vertically on a heavier duty batten formation. Stronger than the lap panel, but not as strong as true closeboarding.

'The above are sold in 6ft widths, starting at 3ft high in 1ft increments, up to 6ft high.'

Continental Panels - A decorative panel, with different designs of infill and tops, with a limited range of heights.

'The above are sold in 1.8m widths and varying heights, these are all in the light beige colour only, fully pressure treated.'

Posts

All panels can either be put on timber posts or concrete slotted posts; it is purely the customer’s personal choice.

On softwood timber posts the options would be: 75 x 75mm 100 x 75mm 100 x 100mm

The panels would be fitted to these via met clips, a U shape bracket, or nails/screws fixed through the side batten, pre drilling is advised. The timber posts can either be concreted into the ground or met posts could be used. If they are being concreted in, the post should go into the ground a minimum of 600mm; if met posts are being used the post will be shorter.

The concrete post has a slot that runs down the complete length of the post, which allows the panel to slot into the post. This is fine on installation, but remember that if a panel needs replacing later on, the panel has to be lifted above the posts and slotted down, e.g. a 6ft high panel would need lifting 6ft in the air to replace.

The options available for slotted posts are: Intermediates Ends Corners

The corners and ends are not handed as the slot is central to the post.

The panels are not actually fixed to the concrete so just sit in the slot; this does mean that they can move around if the panel is thinner than the slot.

Wall Fixing

If the fence is adjoining any walls then a wall plate can be used, either a 100x 47mm or a 75 x 47mm, which is bolted to the wall using suitable fixings, such as thunderbolts, hammer fixings or coach screws; then the panel fixed to this.

Post Tops

The tops of the posts can be left flat, machined or a post cap with or without a finial can be fitted. The finials are commonly acorns or balls, but others are available, these are fitted via a double threaded screw.

Sloping Ground

Remember that if the ground is sloping with the fence line, longer posts will be required to allow for the extra height caused by the panel sitting off the ground. As the panel should always sit level and should never be buried at the high side.